Material Safety Data Sheet


Material Data Safety Sheet Information on this form is furnished for the sole purpose of compliance with the Occupational Safety and Health Act and shall not be used for any other purpose. Customers receiving this MSDS should study it carefully to become aware of the hazards (If any) of the product involved. In the interest of safety, you should notify your employees and contractors of the information listed on this sheet.

  • CELL CAST ACRYLIC
  • Section I
  • CHEMICAL NAME AND FAMILY: POLYMETHYL METHACRYLATE ACRYLIC POLYMER — FORMULA: (C5H602)n
  • Section II
  • ACRYLIC POLYMER: Not Required / 100% / NON HAZ
  • METHYL METHACRYLATE POLYMER: Not Required / TWA / TLV 410mg / M3 / Trace / 80-62-6
  • Section III – PHYSICAL DATA
    • ODOR: NO ODOR
      • BOILING POINT: NOT APPLICABLE
        • PERCENT VOLATILE BY VOLUME: 0.0
        • SOLUBILITY IN WATER: NEGLIGIBLE
          • Section IV – FIRE & EXPLOSION DATA
          • HORIZONTAL BURN LENGTH: Acrylic material has a horizontal burn length from 1.0 to 1.2 in/min for 0.125″ material when tested in accordance with ASTM D-635.
          • SMOKE DENSITY RATING: Acrylic material has a smoke density rating from 4% to 10% for 0.236″ material when tested in accordance with ASTM D-2843.
          • SELF-IGNITION TEMPERATURE: Acrylic has a self-ignition temperature between 460ºC / 860º�F when tested in accordance with ASTM D-1929.
          • FLASH POINT: NOT APPLICABLE
          • LOWER EXPLOSION LIMIT (%): NOT APPLICABLE
          • UPPER EXPLOSION LIMIT (%): NOT APPLICABLE
          • UL 94 FLAMMABILITY CLASSIFICATION: Acrylic material has a flammability rating of 94HB.
          • FIRE EXTINGUISHING MEDIA: CO2, DRY CHEMICAL, WATER SPRAY
          • SPECIAL FIRE FIGHTING PROCEDURES: WEAR RESPIRATOR (PRESSURE-DEMAND, SELF-CONTAINED BREATHING APPARATUS, MSHA / HIOSH – APPROVED OR EQUIVALENT) AND FULL PROTECTIVE GEAR
        • SAFETY GLAZING: Meets ANSI Z 97.1, Safety Glazing Materials used in Buildings. Approved for safety glazing according to model building codes. Suitable for use in Consumer Products Safety Commission, Safety Standard for Architectural Glazing Material under 16 CFR 1201, Categories I & II.
        • BULLET RESISTANCE: 1.25″ thick acrylic is rated as a Level 1 bullet resistant material in accordance with UL 752.